Grizzly G0846, Owner'S Manual

Page: 20 / 52

-18-
Model G0846 (Mfd. Since 02/18)
BACK INJURY HAZARD!
DO NOT overexert yourself
moving your machine—use
assistance for next step.
6. To install adjustable feet, have an assistant
tilt machine and place it on 4 x 4 wood block
for safety, as shown in
Figure 12.
7. Attach (2) feet in mounting holes under main
cabinet and secure each foot with hex nut
(see
Figure 12). Repeat for opposite side.
Note: For permanent floor mounting, refer to
Anchoring to Floor on Page 16.
5. Attach handle to table height handwheel (see
Figure 12) and tighten.
Figure 13. Dust port location.
Dust Port
Work
Table
Figure 12. Installing adjustable feet to base.
Handwheel
Handle
Wood Block
2. Tug hose to make sure it does not come off.
Note: A tight fit is necessary for proper
performance.
Dust Collection
To connect dust collection system to machine:
1. Attach 4" dust hose to dust port under work
table where shown in
Figure 13, and secure
in place with a hose clamp.
Minimum CFM at Dust Port: 400 CFM
Do not confuse this CFM recommendation with
the rating of the dust collector. To determine the
CFM at the dust port, you must consider these
variables: (1) CFM rating of the dust collector,
(2) hose type and length between the dust col-
lector and the machine, (3) number of branches
or wyes, and (4) amount of other open lines
throughout the system. Explaining how to cal-
culate these variables is beyond the scope of
this manual. Consult an expert or purchase a
good dust collection "how-to" book.
This machine creates a lot of wood chips/
dust during operation. Breathing airborne
dust on a regular basis can result in perma-
nent respiratory illness. Reduce your risk
by wearing a respirator and capturing the
dust with a dust-collection system.