Model G0725 (Mfd. Since 02/20)
-3-
Identification
A. Outfeed Table
B. Cutterhead Guard
C. Fence
D. Infeed Table
E. Depth-of-Cut Adjusting Knob
F. ON/OFF Switch w/Disabling Key
G. Dust Port
H. Fence Bracket Assembly
I. Fence Tilting Handle
J. Fence Sliding Handle
Figure 1. G0725 identification (front).
For Your Own Safety, Read Instruction Manual Before Operating Jointer
a) Wear eye protection.
b) Always keep cutterhead and drive guards in place and proper operating condition.
c) Always use hold down/push blocks for jointing material narrower than 3 inches, or planing
material thinner than 3 inches.
d) Never perform jointing or planing on pieces shorter than 8 inches.
G
A
E
B
D
F
C
Figure 2. G0725 identification (rear).
H
I
J
Summary of Contents for G0725
Page 44: ......
