Model g0724 (Mfg. since 09/11)
-15-
4. turn the machine OFF.
5. remove the switch disabling key, as shown
in
figure 11.
test Run
once the assembly is complete, test run your
machine to make sure it runs properly and is
ready for regular operation.
the test run consists of verifying the following:
1) the motor powers up and runs correctly, and
2) the safety disabling mechanism on the power
switch works correctly.
if, during the test run, you cannot easily locate
the source of an unusual noise or vibration, stop
using the machine immediately, then review
troubleshooting on page 22.
if you still cannot remedy a problem, contact our
tech support at (570) 546-9663 for assistance.
to test run the machine:
1. Make sure you have read the safety instruc-
tions at the beginning of the manual and that
the machine is setup properly.
2. Make sure all tools and objects used during
setup are cleared away from the machine.
3. Verify that the machine is operating correctly
by turning it
ON.
—When operating correctly, the machine
runs smoothly with little or no vibration or
rubbing noises.
— investigate and correct strange or unusual
noises or vibrations before operating the
machine further. always disconnect the
machine from power when investigating or
correcting potential problems.
6. try to start the machine with the paddle
switch.
—if the machine does not start, the switch
disabling feature is working as designed.
the test run is now complete.
—if the machine starts, immediately stop the
machine and disconnect power. the switch
disabling feature is not working correctly.
this safety feature must work properly
before proceeding with regular operations.
Call tech support for help.
figure 11. removing switch key from paddle
switch.