Model G0602/G0752 (Mfd. Since 03/17)
-53-
Figure 80. Change gear ball oilers.
Ball Oilers
Oil Type .... Grizzly T23963 or ISO 32 Equivalent
Oil Amount ................................1 or 2 Squirts/Fill
Lubrication Frequency ................................. Daily
This lathe has 10 ball oilers that should be oiled
on a daily basis before beginning operation.
Proper lubrication of ball oilers is done with a
pump-type oil can that has a plastic or rubber-
ized cone tip. We do not recommend using metal
needle or lance tips, as they can push the ball too
far into the oiler, break the spring seat, and lodge
the ball in the oil galley.
Lubricate the ball oilers before and after machine
use, and more frequently under heavy use. When
lubricating ball oilers, first clean the outside sur-
face to remove any dust or grime. Push the tip of
the oil can nozzle against the ball oiler to create
a hydraulic seal, then pump the oil can once or
twice. If you see sludge and contaminants coming
out of the lubrication area, keep pumping the oil
can until the oil runs clear. When finished, wipe
away any excess oil.
Refer to
Figures 79–83 to identify the location of
each ball oiler.
Figure 79. Spindle bearing ball oilers.
Ball Oilers
Ball
Oilers
Figure 83. Leadscrew end bearing ball oilers.
Figure 82. Tailstock ball oiler.
Figure 81. Carriage and cross slide ball oilers.
Ball
Oilers
Ball Oiler
Ball Oiler
Ball Oiler
Ball Oiler
Summary of Contents for G0602
Page 4: ... 4 Model G0602Z G0752Z Mfd Since 06 17 ...
Page 95: ...Model G0602 G0752 Mfd Since 03 17 89 SECTION 10 APPENDIX machine G0602 Charts ...
Page 96: ...G0752 Charts ...
Page 100: ......
