Grizzly G0600, Manual Insert

Page: 18 / 113

G0600 20" x 60" Big Bore Lathe
-15-
Inventory
Major Inventory 1: (Figure 3) Qty
A. Steady Rest Assembly ............................... 1
B.
18" Faceplate ............................................. 1
C. 12" Three Jaw Chuck (On Lathe) .............. 1
D.
14" Four Jaw Chuck ................................... 1
E. Four-Jaw Chuck Lifting Eye ....................... 1
F.
Four Jaw Chuck Key .................................. 1
G. D1-8 Camlock Stud Set .............................. 6
H.
Quick Change Tool Holders ....................... 2
I. Cast Iron Foot Pads ................................... 6
J.
Follow Rest Assembly ................................ 1
NOTICE
Some hardware/fasteners on the inventory
list may arrive pre-installed on the machine.
Check these locations before assuming that
any items from the inventory list are miss-
ing.
Tool Box Inventory: (Figure 4) Qty
K. Tool Box ..................................................... 1
L.
Oil Bottle ..................................................... 1
M. Carriage Lock and Tool Holder Wrench ..... 1
N.
Three-Jaw Chuck Wrench .......................... 1
O. Gap Pin Puller ............................................ 1
P.
Combo Wrench Set 6-30mm ................. 1EA
Q. Hex Wrench Set 1.5-10mm ................... 1EA
R.
#2 Screw Driver Set, Phillips & Flat ...... 1EA
S. MT#5 Dead Centers ................................... 2
T.
MT#7-5 Tapered Spindle Sleeve ............... 1
U. 42-Tooth Metric Change Gear ................... 1
V.
66-Tooth Metric Change Gear ................... 1
W. Cap Screws M6-1 x 25 ............................... 3
X.
Longitudinal and Cross Feed Handle .... 1EA
Y. Adjustable Foot Pad Studs w/Nuts ............ 6
Z.
Gray and Green Spot Paint .................. 1 EA
A
E
D
B
H
Figure 3.
Major item inventory.
F
G
I
J
In the event that any nonproprietary parts are
missing (e.g. a nut or a washer), we would be
glad to replace them, or for the sake of expedi-
ency, replacements can be obtained at your local
hardware store.
After you have inspected your lathe and all the
parts have been removed from the crate, you
should have the following items:
Figure 4. Tool Box Inventory.
K
U
Q
S
T
O
P
N
M
L
V
R
W
X
Z
Y