-40-
Model G0495X (Mfd. Since 07/19)
The infeed table on the Model G0495X has posi-
tive stop bolts that, when properly set up, allow
the operator to quickly adjust the infeed table
between finish/final cuts and shaping/heavy cuts.
We recommend setting the minimum depth of cut
to
1
⁄
32
" and the maximum depth of cut to
1
⁄
8
" for
most operations.
DO NOT exceed
1
⁄
8
" cut per
pass on this machine or the risk of kickback
and serious injury will be greatly increased!
Each positive stop bolt (
Figure 44) controls the
top or bottom range of the table movement. The
jam nuts lock the positive stop bolts in position so
they won't move during operation.
Setting Infeed Table
Figure 45. Infeed table adjusted even with
outfeed table.
Straightedge
Infeed
Outfeed
Calibrating Infeed
Table
The depth scale on the infeed table can be cali-
brated or "zeroed" if it is not correct.
Tools Needed
Qty
Straightedge ...................................................... 1
Wrench 12mm ................................................... 1
To calibrate the depth scale:
1. Set the outfeed table height as described in
Setting Outfeed Table Height on Page 17.
2. Move the cutterhead guard out of the way.
3. Place a straightedge across the infeed and
outfeed tables.
4. Adjust the infeed table until it is level with the
outfeed table, as illustrated in
Figure 45.
Figure 44. Infeed table positive stop bolts.
Top Height
Jam Nut
Jam Nut
Bottom
Height
