Griven RB250, Instruction Manual

Page: 7 / 17

22 English
5.1 Setting operating mode
By using the infrared remote control AL1321 it is possible to select one of the following operating mode.
• DMX512 signal control mode
Each fixture is controlled from DMX512 signal control.
• MASTER-SLAVE or AUTOMATIC mode
The projector operates independently, without DMX512 signal control.
(see chapter 6.0 MASTER/SLAVE and AUTOMATIC function )
• FIXED COLOURS mode
The projector operates independently, without DMX512 signal control.
(see chapter 7.0 FIXED COLOURS function )
Every button push is confirmed by a very short flash coming from the projector.
The following buttons will be used:
5.2 Setting DMX Address
By using the remote control (AL1321) it is possible to select the DMX address and mode:
5.0 Use of the unit
AV TELETEXT
1-/--
AV
79ʗ .....
1 0
PROG +
PROG -
P+
P-
Warning!
Before performing any setting operation it is necessary to log in as reported in the chart below.
Function Buttons Description
LOGIN
1 2 3
It is the first procedure to be performed. After pushing the buttons 1, 2, 3 it is pos-
sible to access the functions settings. The function is confirmed by 1 white flash
coming from the projector.
LOGOUT
/
The logout is automatic after 5 minutes of missing reception of the signal coming
from the remote control. Once th projector logs out it is not possible to perform
any other operation before a new login.
Funzione Tasti Descrizione
Change
of DMX
mode
+ 1 /.../ 6
Select the nuber of DMX channels. If the setting is correct then the projector will
confirm the procedure by performing 2 white flashes. (e.g. Projector RGBW 5
channels, press 5)
Change
of DMX
address
+ 0....9
79ʗ
The new entered address must feature 3 digits (e.g. 0 6 7). If the address is correct
then the projector will confirm the procedure by performing 3 white flashes