English
25
5.1 Setting operating mode
By the control panel it is possible to select one of the following operating modes:
• using DMX512 signal control mode
Each fixture is controlled from DMX512 signal control.
(see chapter
8.0 DMX function
)
• MASTER-SLAVE or AUTOMATIC mode (only RGBW and DW)
The projector operates independently, without DMX512 signal control.
(see chapter
MASTER/SLAVE and AUTOMATIC function
)
• using FIXED COLOURS mode (only RGBW and DW)
The projector operates independently, without DMX512 signal control.
(see chapter
FIXED COLOURS function
)
The unit NORMALLY works in DMX mode and, on turning on, the display will read the number of DMX address (e.g.
012).
If on turning on the display will read “AUT”, it will mean that the unit is working in AUTOMATIC mode.
Disable this function to go back to the DMX mode.
If on turning on, the display will read “COL”, it will mean that the unit is working in FIXED COLOURS mode.
Disable this function to go back to the DMX mode.
5.2 Unit control panel
The display of the unit is programmed to turn off
automatically after 10 seconds of non working.
To activate it just press any key.
In the presence of the DMX signal the red led will steadily
be on while in the absence of DMX signal the led will flash.
The SET led is on during:
• DMX address is setting
• menu setting
5.2.1 Reading the display and using controls
MENU
button:
By pushing the “MENU” button the display will show the main menu or you can exit from function and go back to
main menu.
By pushing the “MENU” button when is show the DMX address, you will enter in the main menu.
• Address setting
ADR
• Channels number setting
CHN (only RGBW and DW)
• MASTER/SLAVE and AUTOMATIC mode
AUT (only RGBW and DW)
• FIXED COLOURS mode
COL (only RGBW and DW)
• Dimmer whitout DMX
DIM ( only monochrome)
• LED temperature
LET
• Driver temperature
DRT
• Body temperature
BOT ( only Polar version)
• Heating Power
HEP ( only Polar version)
• Default settings
DEF
• Release software
REL
UP
and
DOWN
buttons:
By pushing the “UP” and “DOWN” buttons, values of the function which is shown in the display can be changed.
ENTER
button:
Keep the “ENTER” button pushed, until the display and the SET led flash, in order to memorize the function which
5.0 Use of the unit
