To prevent possible SERIOUS INJURY or DEATH:
• NEVER allow small children near batteries.
• If battery is swallowed immediately notify doctor.
To reduce risk of fire, explosion or chemical burn:
• Replace ONLY with CR2032 coin batteries.
• DO NOT recharge, disassemble or heat above
100°C or incinerate.
4 Buttons
• Configure each button to operate any current
operator in the Grifco, Merlin or Chamberlain DIY
portfolio
• Buttons have raised dots to indicate door number
• Buttons can be configured to open multiple doors
or open / close an individual door
Keyring
• Keyring included
LED Indicator
• Green LED indicates when
transmitter is in operation
(useful battery check)
• Used when programming
(learning) transmitters to
operators
Surrounding Metal Edge
• Extra durability & styling
• Protects the edge of the
transmitter against potential
damage due to dropping
Device Naming Panel
• White space to
name the transmitter
• Mark the apartment
number, transmitter
reference code or
name etc
Se2.0 / S
• Transmitter can be used with operators
using Se2.0 or S codes
• Any button can be programmed to
operate any operator with either code
UNIT 1
(example only)
4-CHANNEL TRANSMITTER
Wireless Keyring Transmitter compatible with S and Se2.0
MODEL: E960G
2. Programming via the Grifco C10A (Se2.0) Wall Control
2.0 operators are supplied with a
RADIO LOCK
bridge on the main circuit board.
This lock will have to be removed before programming any wireless transmitters. The
RADIO LOCK can be replaced after programming is complete. See the 2.0 manual
for more information. To program the wireless transmitter perform the following steps:
1. Press and hold the
SET
button on the GRIFCO front panel, then;
2. While holding the
SET
button, press the STOP button
5 times
(the green status light
will light then continue flashing, indicating learn mode)
3. Let go of the
SET
button
4. Press a button on the wireless transmitter
5. The orange
LIMIT ERROR
light will flash to acknowledge the learned device
6. Press another button until all buttons and/or devices are learned
7. Press
STOP
button on the GRIFCO front panel to exit learn mode
1. Introduction
This transmitter is for use with Grifco commercial door operators with S 2.0 radio-
on-board or legacy S systems. The door opener activates on button press.
Grifco C10A (Se2.0)
Wall Control
1.
UP
- Moves the door upwards
2.
DOWN
- Moves the door
downwards
3.
STOP
- Stops the door
4.
SET
- SET button
5.
POWER ON
- Shows when
the unit is mains powered
6.
STATUS
- Shows the status of
the unit
7.
LIMIT ERROR
– When lit
indicates limits are not set
The wireless transmitter can be
used to TOGGLE the action of the
door between close / stop / open
if an obstruction detection device
is installed, or stop / open only if
no obstruction detection device is
installed.
1
5
7
2
6
4
3
One Year Limited Warranty
Chamberlain warrants to the original purchaser of this product that it is free
from defect in materials and/or workmanship for a period of 1 year from the
date of purchase.
Note: Batteries are not covered by warranty
