Grifco D-DRIVE DDC-22, Installation Manual, Page: 38 / 52

38
9. COMMISSIONING
9.11 SETTING UP A PROGRAMMABLE INPUT
INPUT PIN PARAMETER DDC-22 DEFAULT DDI DEFAULT
1 52 P.501 0101 0101
2 53 P.502 0402 0402
3 54 P.503 0701 0701
4 72 P.504 0201 0201
5 75 P.505 0520 0520
6 82 P.506 0301 0301
7 85 P.507 0601 0601
8 61 P.508 0801 0802
9 64 P.509 0903 1003
10 65 P.50A 1001 1001
VALUE FUNCTION VALUE FUNCTION
0000
OFF (disable)
0701
CLOSE with clearance timer
0101
OPEN1 to full open position, with auto close &
clearance timers
0801
INTERLOCK IN CLOSED POSITION. No deadman
override.
0102
OPEN1 to part open position, with auto close &
clearance timers
0802
INTERLOCK in closed position. Deadman override
possible.
0106
OPEN2 to full open position from inside, with auto
close & clearance timers
0903
BYPASS Mid Limit
0110
OPEN1 to full open position from outside, with auto
close & clearance timers
1001
DISABLE auto close time
0201
IMPULSE open & close (reversing closing) with
auto close & clearance timers
1003
Disable intermediate stop, NO contact
0301
Permanent-OPEN, NO contact, 1. Intermediate
stop 2. OPEN, without hold open time, without
clearance time, both directions
1004
DISABLE commands from outside
0402
Stop-command, NO contact
1405
PHOTOCELL stop & reverse during opening, pause
when closing
0501
PHOTOCELL stop & reverse when closing
1422
SAFETY EDGE stop & when opening. Suitable for 8k2
Input only (e.g. Input 10)
0520
Safety: Reversing when CLOSING, NO contact,
with testing in end position OPEN
1612
SAFETY EDGE free ride when opening. Suitable for
8k2 Input only (e.g. Input 10)
0601 Manual operation for OPENING and CLOSING,
NO contact
1801
LOOP1 Loop detector parameter p.66x
Select the programmable Input Profile from the table below.
Select the Input number that you wish to use from the table below.