Grifco D-DRIVE DDC-22, Installation Manual, Page: 34 / 52

34
CAUTION
By default, the controller is set to Latch Up and Latch Down mode. If entrapment protections devices are not installed the
controller will display the message E.105, and the controller will be in Latch-Up / Inch-Down mode.
To configure the controller to Deadman Inch-Up / Inch-Down mode, set P.980 to 2 (refer below to enable access to Parameter
Selection mode.).
CODE DESCRIPTION
E.105 Safety Beam faulty, not connected, obstructed or mis-aligned
E.360 Safety Edge or Light Curtain not configured
F.211 External Safety Brake or Wire Link (Pin 41/42) not connected
CAUTION
The 3 seconds refers to the time until the screen dots stop flashing.
The following messages may be displayed after setting limits. Refer to Input Messages below.
9. COMMISSIONING
9.2 ENTERING PARAMETER CHANGE MODE
Use the follow procedure to enter the Parameter Operation mode.
1. Isolate power. Open the enclosure and set MCB dip switch (shown below) to ON to enable Service
Mode.
2. Close the cover of the enclosure and energise the controller.
3. Press and hold the UP and STOP buttons for 3 seconds to enter the Parameter
Selection mode.
9.3 ENTER ADVANCED PARAMETER MODE
1. Use the UP and DOWN buttons to navigate to P.999
2. Press STOP briefly to enter the P.999 parameter setting
3. Use the UP or DOWN buttons to change the value to ‘3’
4. Press and hold the STOP button for 3 seconds to save the setting.
5. Press STOP briefly to return to Parameter Setting menu.
6. Use the UP or DOWN buttons to navigate to Parameters listed in the Advanced Parameter Guide.
7. Press STOP briefly to enter the parameter.
8. Use the UP or DOWN buttons to change the value to of the parameter.
9. Press and hold the STOP button for 3 seconds to save the new value.
10. Press STOP briefly to return to Parameter Setting menu.
11. Press and hold the STOP button for 3 seconds to exit Parameter Selection Mode.