19
SYSTEM SETUP
CONFIGURATION DATA
The system has the capability of remembering all configuration data previously set.
After removing power to the system, and then re-powering, the settings remain intact until reset by
the operator.
After setting the configuration, the operation of the system depends only on selecting which winch is
in use. Changing the winch will automatically change the lifting point and the parts of line to the
values previously set for the selected winch.
NOTE: Always check the point of lift and parts of line following selection of the winch.
WARNING!
The displayed load and capacity are based upon the current selected point of lift.
Neither the RCI 514 system, nor the crane capacity chart, allows for lifting from more
than one hook at a time.
Summary of Contents for MicroGuard RCI 514
Page 30: ...30...
