67
W450769A 01/14
3.7.10.2 Installing the Slip-Ring Assembly
1. The new Slip-Ring Assembly is pre-lubricated with grease. Do not wipe off lubrication.
2. Attach the brown slip-ring wire from the lower half of the new slip-ring to TB1-5 on the sensor
baseplate assembly. Ensure the brown signal wire is also correctly connected.
3. Attach the black (or white) slip-ring wire from the lower half of the new slip-ring to TB1-6 on the
sensor baseplate assembly. Ensure the black signal cable wire is also correctly connected.
4. Screw the bottom half of the slip-ring to the shaft with the two Phillips screws. Ensure the wires
exiting through the center of the shaft are not trapped.
5. Connect the Reeling Drum cable to TB2 on the arm of the slip-ring. The braided shield connects
to the slip-ring TB2 black wire and the center of the cable connects to the slip-ring TB2 brown
wire.
6. Secure the Reeling Drum cable to the arm of the slip-ring with two cable ties.
7. Ensure the slip-ring is plugged in all the way.
8. Replace the Reeling Drum cover.
