GreenWorks LMF401 Operator'S Manual Download Page 5

4. Hold the the grass catcher by its handle and engage the

hooks on the door rod.

5. Close the rear discharge door.

3.5

INSTALL THE MULCH PLUG

Figure 5.

1. Remove the grass catcher.
2. Open the rear discharge door and hold it.
3. Hold the mulch plug by its handle and fit it in the

discharge chute.

4. Close the rear discharge door.

3.6

INSTALL THE SIDE DISCHARGE

CHUTE

Figure 6.

 

CAUTION

When you use the side discharge chute,

do not install the grass catcher.

keep the mulch plug installed.

1. Open the side discharge door and hold it.
2. Line up the recesses of the side discharge chute below the

pivot.

3. Close the side discharge door.

3.7

SET THE BLADE HEIGHT

The machine can be set to different blade heights.

Figure 7.

1. Pull the height adjustment lever rearward to increase the

blade height.

2. Pull the height adjustment lever forward to decrease the

blade height.

3.8

INSTALL THE BATTERY PACK

Figure 8.

 

WARNING

If the battery pack or charger is damaged, replace the
battery pack or the charger.

Stop the machine and wait until the engine stops before
you install or remove the battery pack.

Read, know, and do the instructions in the battery and
charger manual.

 

NOTE

The machine has a battery storage compartment that helps
store the battery.

1. Open the battery door.

2. Align the lift ribs on the battery pack with the grooves in

the battery compartment.

3. Push the battery pack into the battery compartment until

the battery pack locks into place.

4. When you hear a click, the battery pack is installed.
5. Close the battery door.

 

NOTE

The engine starts only when you put in the safety key.

3.9

REMOVE THE BATTERY PACK

Figure 8.

1. Open the battery door.
2. Remove the safety key.
3. Push and hold the battery release button.
4. Remove the battery pack from the machine.

4

OPERATION

 

WARNING

Wear eye protection during operation.

4.1

START THE MACHINE

Figure 9.

1. Put in the safety key.
2. Push and hold the start button.
3. While you hold the start button, pull the bail switch in the

direction of the handle bar.

4. Release the start button to start the machine.

Soft-Start

This Li-ion machine has a “soft-start” feature.

When you start the machine, it goes to full speed after
approximately 3 seconds.

 

NOTE

If the machine does not start, remove the battery pack and
examine the mower deck to make sure that:

no grass catches on the blade.

the blade can turn freely by hand.

4.2

STOP THE MACHINE

Figure 9.

1. Release the bail switch to stop the machine.

 

WARNING

Wait until the blades fully stop before you start the machine
again. Do not quickly turn the machine off and on.

5

English

EN

Reviews: