34
Motor running, but
cutting abnormal.
Motor stops after about 3
seconds.
Recharge the battery.
If the unit cuts off and beeps
during a cut, it went into
protection mode. This protects
the PCB from damage.
Release the trigger and restart the
chainsaw. Let the chainsaw do the work
and do not force the cut.
Battery is not charged.
Charge the battery. Refer to the battery
and charger manual for correct charging
procedures.
The saw chain needs lubrication,
and will increase friction if not
properly maintained.
Make sure the chain is always lubricated by
never letting the bar and chain oil run low.
Incorrect battery storage
temperature.
Allow the battery pack to cool until it drops
to room temperature.
TROUBLESHOOTING
