W A R N I N G
Follow these instructions in order to avoid injury and to reduce the risk of electric shock or fire:
• Replace the battery pack or the charger immediately if the battery case or charger cord is
damaged.
• Verify that the switch is in the OFF position before inserting or removing the battery pack.
• Verify that the battery pack is removed and the switch is in the OFF position before inspecting,
adjusting, or performing maintenance on any part of the chainsaw.
• Read, understand, and follow the instructions contained in the section entitled Charging
Procedure.
15
ASSEMBLy INSTRUCTION
NOTE: The battery pack fits into the handle snugly in order to prevent accidental dislodging. It
may require a strong pull to remove it.
TO REMOVE THE BATTERY:
1. Press the battery release button (1) on the chainsaw. This will cause the battery to raise out of
the tool slightly.
2. Grasp the chainsaw (2) firmly and pull the battery out of the handle.
INSTALLING THE BATTERY PACK
• Align the rails (3) of the battery pack with the cavity.
• Grasp the chainsaw (2).
• Push the battery pack into the handle until the latch locks into place.
• Do not use force when inserting the battery pack. It should slide into position and “click”.
Fig. 7
2
1
3
BATTERY PACK (See Figure 7)
I M P O R T A N T
The battery pack is not charged when it is purchased. Before using the chain saw for the first
time, place the battery pack in the battery charger and charge it fully. Be sure to read all safety
precautions, and follow the instructions in the section entitled Charging Procedure. With regular
use, the battery will require shorter charging times. When storing the chain saw for a prolonged
period of time, remove the battery. When the chain saw is going to be used again, charge the
battery pack for at least a full charging period. This product has no memory effect.
I M P O R T A N T
This lithium-ion battery pack is equipped with an internal circuit breaker which will automatically
shut off the power to the tool and then reset itself once cooled. follow these steps if an overload
occurs while under heavy use:
1. Release the power switch and restart tool by depressing switch.
2. The battery may need to be removed for approximately 1 minute, allowed to cool, and then
reinstalled for use.
