1
.Open the cover of the PIR sensor
with a flat screwdriver. A gentle
twisting will remove the cover of
the PIR Sensor.
2
.Insert two
1.5
V “AA” alkaline
batteries in the PIR sensor,
observe polarity.
3
.Set the house codes (
1
-
16
), it
must be matching with the code
set in the chime receiver.
(Diagram A)
4
.Use the
3
position slide switch to
select a different chime tune.
Note - PIR sensor and bell push-
es can be set to different tunes.
(Diagram A)
5
. Use
2
-position slide switch to
adjust the HI/LOW sensitivity.
Factory pre-set to low sensitivity.
This adjusts the range of the PIR
Sensor. (Diagram A)
6
.Locate a good position indoor or
outdoor within the detection
range of the PIR Sensor.
7
.Place the back plate in the chosen
position, drill two
4.76
mm holes
and insert the wall plugs, then
tighten the plate on wall with the
screws supplied. Do not mount
on or next to a metal surface.
8.Position the cover over the back
plate so that the lip on the back
plate engages into the slot. Make
sure the rubber gasket is properly
seated. Push the PIR cover back
to the back plate until it snaps into
position.
9
.The PIR Sensor detects any
INSTALLATION
• For use with wireless chimes
• Use instead of, or in conjunction with
other bell pushes to alert the approach
of visitors/intruders
•
433
MHz,
16
code, up to
50
M range
• Detection range
3
M
• Detection angle
60
degree
•
2
x
1.5
V AA battery
• Indoor & Outdoor Use
• CE-EMC / LVD / R&TTE approved
• RoHS compliance
DW
080
A-C
Security PIR Sensor
