1
. Equipment provided
: Locate all equipment provided with your order. The following
equipment may be provided – make sure to look at your packing slips and purchase orders
to determine exactly what is included in your system.
a.
Generator Control Panel
b.
Reverse Osmosis system
c.
Governing humidity
d.
Installation and Maintenance Manual
2. Humidifier location
: Location of the humidifier
Installer. The following rules should be followed:
A.
Place the Control Panel in a place where the outlet fog will
surfaces. Make sure to verify the air patterns in the room to preclude any adverse
flows that would cause the fog to impinge upon any walls, the control cabinet or
other surfaces.
B.
If the unit is feeding a test chamber or room then
cabinet as close as possible to the dispersion point of the fog and no greater than
10’ ft. if possible.
The longer the run of discharge tubing the more your losses of
fog will be. (Consult with the Factory if thi
INSTALLATION:
I) Control Panel Location and Piping:
A. As stated above locate
distance from the dispersion point
B. Make sure the Control Panel
C. When attaching tubing to the inlet and outlet stubs on the Control Panel make
sure they are water tight.
D. Sealant can be used on the
adhesive because these tubes will need to be loosened during maintenance.
CAUTION:
When piping try to avoid creating
piping. If you cannot avoid doing so then
trap locations. (see Fig. 1 )
: Locate all equipment provided with your order. The following
make sure to look at your packing slips and purchase orders
to determine exactly what is included in your system.
Generator Control Panel
Reverse Osmosis system including 4 gal. storage tank (if applicable)
Governing humidity sensor
Installation and Maintenance Manual
Location of the humidifier is the preference of the End User or
Installer. The following rules should be followed:
Place the Control Panel in a place where the outlet fog will not impinge on any
surfaces. Make sure to verify the air patterns in the room to preclude any adverse
flows that would cause the fog to impinge upon any walls, the control cabinet or
If the unit is feeding a test chamber or room then try and keep the control
cabinet as close as possible to the dispersion point of the fog and no greater than
10’ ft. if possible.
The longer the run of discharge tubing the more your losses of
fog will be. (Consult with the Factory if this is a problem
Location and Piping:
ocate the Control Panel within 10’ ft of equivalent piping
the dispersion point.
Make sure the Control Panel is installed LEVEL! VERY IMPORTANT!
tubing to the inlet and outlet stubs on the Control Panel make
sure they are water tight.
Sealant can be used on the stubs if desired for complete seal.
adhesive because these tubes will need to be loosened during maintenance.
When piping try to avoid creating water “traps” or low points in the
piping. If you cannot avoid doing so then be sure to plumb a mini-drain from such
2
: Locate all equipment provided with your order. The following
make sure to look at your packing slips and purchase orders
(if applicable)
is the preference of the End User or
not impinge on any
surfaces. Make sure to verify the air patterns in the room to preclude any adverse
flows that would cause the fog to impinge upon any walls, the control cabinet or
try and keep the control
cabinet as close as possible to the dispersion point of the fog and no greater than
10’ ft. if possible.
The longer the run of discharge tubing the more your losses of
’ ft of equivalent piping
is installed LEVEL! VERY IMPORTANT!
tubing to the inlet and outlet stubs on the Control Panel make
But not
adhesive because these tubes will need to be loosened during maintenance.
water “traps” or low points in the
drain from such