1. Disconnect the mains supply before
proceeding with the installation.
2. These products should be connected to a
lighting circuit or fused at a maximum of 5A.
3. The transformer incorporated in these
products has an isolating 20VA loading
and an output of 230V or 115V on the
dual voltage version and 230V on the
single.
4. Ensure products plugged into this unit are
rated less than 20VA.
These units must be mounted horizontally
on a vertical surface. Please read the
instructions fully before attempting
installation and retain for future reference.
1. Remove the diffuser by gently pressing the
sides at the point indicated, in Fig.1, and
lift out.
2. Remove the back plate of the shaver light
and using as a template mark fixings in the
required position on the wall, and drill
fixing holes accordingly.
3. Connect the cable by passing through the
hole in the back plate and follow the
codes as listed:
Live (L) = Brown or Red, Neutral (N) = Blue
or Black, conductor size 0.5mm to 1.5mm
solid or stranded, ensure that no strands of
cable are visible outside the connector.
4. Place shaver light into position with back
plate secured, and screw onto wall with
appropriate screws through the holes in
the base of the unit.
5. Insert the lamp and replace diffuser.
6. Switch back on the mains supply and
shaver light is now ready for use.
Safety Note:
The unit will not work if the diffuser is not in
place.
Safety and Installation
Instructions for Bathroom
Single & Dual Voltage
Shaver Light
Part No: STA4NL
SAFETY INSTRUCTIONS
INSTALLATION INSTRUCTIONS
IMPORTANT
This unit should be installed to current IET
wiring regulations, if in doubt consult a
qualified electrician.
Fig.1
STA4NL Ins.qxp_Layout 1 09/05/2018 11:21 Page 1
