Cleanly cut off damaged part of rod.
If necessary carefully drill/ream out
any fibreglass and/or residual glue
from the metal end.
Glue the metal end onto the rod with
a good quality super glue.
All Rod measurements are nominal.
We reserve the right to change the
design and specification to improve
quality and enhance performance.
If joined rods are bent beyond the
following recommended rates of
bend, the rod and/or brass fitting may
be damaged as a result of bending.
SAFETY
Operating Instructions
for 10M Rod Kits
DR10 & GR10 (Luminescent)
To maintain the integrity and flexibility
of this product it is essential to keep the
threaded parts fully mated. Failure to
do so may cause the threads to snap
and invalidate the warranty.
Keep threads free of dust and debris.
Regularly clean them with a stiff brush.
Do not lubricate the threads as this will
attract debris and/or allow rods to
easily unscrew.
If the rods get caught on an
obstruction do not force them. Gently
ease the rods back and forth. If the
rods meet an obstruction e.g. a joist, try
‘flicking’ them to make the end
‘jump’ over.
REPAIRS
RECOMMENDED MINIMUM
BEND RADIUS OF JOINED RODS
PLEASE NOTE -
Fibreglass is a mild irritant to those
with sensitive skin. Wearing gloves is
recommended when using the rods.
If you have a reaction (redness or
mild itching) wash your hands
throughly. If the reaction persists for
longer than 48 hours consult a doctor.
INSTRUCTIONS
DR10 GR10 Ins May 18.qxp_DR10 Instructions 21/05/2018 15:38 Page 1
