Multi Variable Air Conditioners Ducted Type Indoor Unit
3
3 Preparations for Installation
Note!
Product graphics are only for reference. Please refer to actual products. Unspecified measure
unit is mm(in.)
3.1 Standard Fittings
Please use the supplied standard fittings listed below as instructed.
No.
Name
Appearance
Q'ty
Usage
1
Wired Controller
1
To control the indoor unit
2
Drain Hose Assembly
1
To connect with the hard
PVC drain pipe
3
Special Nut
1
To be used for connecting
the refrigerant pipe
4
M10X8 Nut with Washer
4
To be used together with the
hanger bolt for installing the
unit
5
M10 Nut (M10X8.4 Nut)
4
To be used together with the
hanger bolt for installing the
unit
6
M10 Washer (Spring Washer
M10X2.6)
4
To be used together with the
hanger bolt for installing the
unit
7
Insulation
1
To insulate the gas pipe
8
Insulation
1
To insulate the liquid pipe
9
Sponge
2
To insulate the drain pipe
10
Fastener
8
To fasten the sponge
11
paper pattern for installation
1
Locate the drill hole on
ceiling
3.2 Location for Installation
(1) The appliance shall not be installed in the laundry.
(2)
The top holder must be strong enough to support unit’s weight.
(3) Drain pipe can drain water out easily.
(4) There is no obstacle at inlet or outlet. Please ensure good air circulation.
