Multi Variable Air Conditioners Duct Type Indoor Unit
16
(2) Connection of Multi-twisted Wire (shown in Fig 5.1.2).
1) Use a wired stripper to strip away about 10mm (3/8 in.) of the insulation layer at the end
of multi-twisted wire.
2) Use a screwdriver to remove screw on the wiring board of air conditioner.
3) Use a round terminal fastener or a plier to securely fasten the round terminal with each
core wire of the multi-core wire.
4) Confirm each position of core wire on the round terminal and then use a screwdriver to
tighten the terminal screw.
Fig 5.1.1 Fig 5.1.2
5.2 Power Cord Connection
Power supply of each indoor unit must be from the same source.
Fig 5.2
Remark: The maximum number of indoor units that can be connected depends on the capacity of
outdoor unit. For specific details, please refer to the capacity configuration part.
(1) For air conditioner that uses single-phase power.
1) Remove the cover of electric box of indoor unit.
2) Lead the power cord across the rubber ring.
3) Connect the power cord to the L1, L2 terminals and the grounding screw.
4) Fasten the power cord with a wire clamp.
Summary of Contents for GMV-ND07PLS/B-T
Page 23: ...Multi Variable Air Conditioners Duct Type Indoor Unit 19 Fig 5 5...
Page 26: ......
