GREAT PLAINS YP1630F-1630, Operator'S Manual, Page: 61 / 142

YP1630F-1630 and YP1630F-1670 Table of Contents Index Adjustments
Great Plains | 401-832M | 2018-07-31 Table of Contents Index 57
Exchanging Meters
These steps are only for changing between types of
meters. Changing brush meter seed plates (page 60)
does not require meter removal.
Agricultural Chemical Hazard:
Follow material supplier recommendations carefully. Handle
the meter as if it were treated seed. use supplier-recommended
cleaning agents. Any seed treatment build-up inside a meter is
likely to be at a higher concentration than on the actual seed.
Refer to Figure 60
1. Remove and empty the seed hopper (page 73). Put
the lid back on to capture any bolts
that fall away.
2. Remove two nuts washers and the meter .
3. Install new meter. Tighten
5 
16
-18 nuts to
Grade 2 torque specification. Do not over-tighten, or
you may damage the hopper. Reinstall the hopper
(page 34).
4. Clean and dry removed meters. See “ Finger Pickup
Meter Maintenance ” on page 82.
5. Store removed meters in pest-proof containers, such
as plastic bags.
Figure 60
Removing Meter
25459
4
3
2
1
6
5
1
2 3 4
2