2018-07-23
401-652M
YP-425, 625, 825, & 1025-A3P
Operating Instructions
32
9.
Inspect the hopper for leftover seed and debris.
Clean out anything other than the seed to be
planted. See “
Possible Agricultural Chemical Hazards:
Read and follow all supplier cautions for safe handling of
treated seed.
Irritant and Chronic Exposure Hazards:
Do not mix lubricants into seed with hands or any part of body.
Wear protective equipment. Use tools. See page 95.
10. Pre-mix seed and lubricant.
For clean seeds other than Milo, cotton, and
sunflowers sprinkle
1
/
4
cup of Ezee Glide Plus per
bushel or unit (60 ml per 35 liters) of seed.
For milo, cotton, and sunflowers double the
application to
1
/
2
cup (or more) per bu.or unit (120 ml
per 35 liters) of seed.
Population Risk: The
seed must be properly lubricated,
starting with the first seed through the meter. If unable to
pre-mix prior to loading, pre-mix at least one gallon (4 liters)
per hopper, and load this seed first. Fill the hoppers to half full
with fresh seed. Add half the lubricant and stir with a tool.
Complete filling the hoppers and sprinkle the remaining
lubricant on top.
11. Add seed and lubricant to hoppers.
12. Close lids. With lid tilted up at a slight angle, hook
the two front hinge lugs under the front hopper lip.
Swing down, keeping fingers clear of lug, and latch
the single rear lid lug on rear hopper lip.
Equipment Loss Risk:
Check that lids are closed properly or the lid may come off in
transport.
Figure 23
Hopper Lid Stored for Loading
36909
82%
Figure 24
Adding Seed Lubricant
34710
