GREAT PLAINS Yield-Pro YP4025A-48TR20, Operator'S Manual

Page: 25 / 190

YP4025A-48TR20 Table of Contents Index Preparation and Setup 21
2019-03-19 Table of Contents Index 411-198M
Parking Stands
Store Main Parking Stand
Refer to Figure 9
1. Raise the tractor hitch slightly to lift parking stands
off ground.
2. Remove the lower pin and the upper pin
holding the parking stand .
3. Move the stand from under the tongue to an inverted
position in the bracket on the left side on the
tongue. Pin in place.
Storing 3-Point Parking Stands
Refer to Figure 10 (shown without tractor for clarity)
1. For the standard 3-point hitch, store the two forward
stands by either of the following methods:
•
Remove the top pin , swing the stand out, up
and vertical around the bottom pin , and re-insert
the top pin , or
•
Remove the bottom pin , swing the stand inward,
to a horizontal positional under the hitch, and insert
the removed pin at hole
under the stand.
Refer to Figure 9
2. Adjust the top link of a 3-point long enough so the
ball swivel does not bottom out when fully raised.
3. Secure hoses so they do not get caught in ball
swivel . Failure to do so could cause hose to be
crushed requiring hose replacement.
Figure 9
Main Parking Stand Stored
29242
2
1
3
4
5
1 2
3
4
Figure 10
Storing 3-Point Stands
26034
7
9 8
6
6
6
7 6
8
7
8
9
5
5