06/12/2019
401-754M
YP625PD
Operating Instructions
24
Loading Dry Fertilizer
If fertilizer will not be applied, uncouple the fertilizer
meter shaft at the left end of the left hopper. Pin the
coupler clear of the shaft joint.
Loading fertilizer prior to transport is not recommended.
Although the meters are not turning during transport, it is
possible for some material to spill through the meters,
particularly on rough roads.
Suitable Materials
Use only dry granular fertilizer. Granules must flow freely,
and must have a maximum diameter smaller than 7 mm
(to avoid bridging clogs in the applicator tube outlets).
Agricultural Chemical Hazard:
Wear protective equipment suitable for the material to be used,
and the material previously dispensed from the hoppers. Avoid
contact with skin or eyes. Avoid breathing dust.
System Inspection
Verify that both rear cradle pins are installed on all
hoppers. See Figure 82 on page 75.
Remove the lid on each hopper and inspect for:
•
residual fertilizer incompatible with next use
•
contaminants
•
debris that might clog the meter inlets
•
trapped animals, lost tools, etc.
If it is necessary to clean a hopper, see “
Hopper Lid Operation
Refer to Figure 17 and Figure 19
To unlock the hopper lid, lift the rubber latches out of
the metal keepers .
The keeper hardware tends to snag under the
hopper lip. Pull the lid edge forward and lift.
To open the lid, lift the front edge up and slide the lid
back into a vertical position behind the hopper. The lid is
held by retaining straps .
Null4:
Figure 16
Empty 2- and 3-Outlet Hoppers
31866
1
Null4:
Figure 17
Hopper Latch Open and Closed
31866
2
3
Null4:
Figure 18
Hopper Lid Open
31865
4
5
