GREAT PLAINS Yield-Pro Air-Pro YP2425A, Operator'S Manual

Page: 58 / 180

Great Plains | 401-626M | 2019-06-11 Table of Contents Index 54
YP2425A Table of Contents Index Operating Instructions
Row Units Checklist Page
Preset depth handles to 7 holes showing
above “T”
76
Preset down force springs to first notch
(lightest) setting for most conditions, 2nd
notch otherwise)
71
Set all unit-mounted coulters to
1
/
4
inch
shallower than opener blades.
74
Check coulter alignment to row 75
Check closing wheel alignment 87
Set closing wheels to first notch (light
setting)
87
Check action and contact of side depth
wheels
77
Gauge wheel scraper gap (if installed) 78
Treatments (Options) Checklist Page
Confirm Clutch Folding Module “Fert.Pump”
switch OFF
51
Check tractor-mounted components
a
a. Check supplier manual for tanks and pump. Check
fertilizer section of monitor manual.
Pump chains(s), drive wheel if ground drive
Execute Tank Cart Checklist
b
b. See SML or PFC2000/PFC1600 Manual.
Check for correct orifice plates
c
c. Check Seed Rate manual, and manual for fertilizer pump
system.
Fill system with 100 gallons of water, and
check for leaks
-
Check all row unit lines are connected, free
of kinks, and discharge tube/nozzles are
clear
-
Inlet and hose valves open
SmartBox system loaded, powered up
Hydraulic System Checklist Page
Check tractor hydraulic reservoir full -
Inspect connections for leaks -
Perform a raise and lower operation 28
Set Clutch Folding Module switch
“Marker/Fold” to “Marker”
39
Hydraulic Planter Drive Checklist Page
Check chain lubrication and slack 111
Input initial values for desired population
a
a. Refer to seed monitor manual and Seed Rate manual.
Calibrate radar speed sensor pulses with
planter lowered.
155
Lubricate slider joints on drive shafts 114
Check clutch operation 39
Meters Checklist Page
Correct disks for seed
a
a. Refer to Seed Rate manual.
Seed inlet shutters set
Corn?
Check timing of meters for twin-row
a
Check chain tension
a
Initial meter pressurization set 46