![GREAT PLAINS Yield-Pro 3PYPA Operator'S Manual Download Page 110](http://html1.mh-extra.com/html/great-plains/yield-pro-3pypa/yield-pro-3pypa_operators-manual_2259527110.webp)
Great Plains
| 401-647M | 2019-06-11
Table of Contents
Index
106
3PYPA
Table of Contents
Index
Maintenance and Lubrication
Meter Brush Replacement
Consult the Parts manual (401-647P) for current
replacement part numbers.
Refer to Figure 133
Tufted Brush Replacement
1. Remove and save both 10-24 hex head cap
screws
and Nylock nuts (not shown).
2. Remove the tufted brush assembly
, and replace
with new assembly.
3. Reinsert the 10-24 screws, and restart the Nylock
nuts. Carefully tighten each nut just until plate has no
play under the screw heads.
4. Add a half turn to the nuts. Do not tighten fasteners
to normal 10-24 torque, or the plate may fracture.
Strip Brush Replacement
Do not loosen or remove any of the three
5
/
16
-18 cap
screws
retaining the brush holder.
1. Insert the flat blade of a large screwdriver into the
slots of the brush holder snaps
. Turn each snap
clockwise to release brush holder
.
2. Prepare to catch drop brush
(which will fall lose).
Slide brush holder left and up to free front edge from
under washer
. Remove brush holder.
3. Remove used strip brushes from the holder by
sliding them downward out of the grooves.
Refer to Figure 134
4. Insert replacement strip brushes into grooves at
holder bottom so that notched ends
are at the
bottom.
Refer to Figure 133
5. Check strip brush positioning with a trial reinsertion
of the brush holder. The ends of the long brush must
fit snugly into meter housing grooves at top
and
lower rear
. The bottom end of the short brush
must fit snugly in the lower front housing groove
.
If any significant force is require to re-seat the brush
holder, a strip brush is likely too high or too low.
6. Relax the position of the brush holder, reposition the
drop brush (see below), and re-seat the brush
holder.
7. Starting with the bottom snap, swing snaps
back
into engagement.
Figure 133
Brush Replacement
29719
13
14
16
11
13
17
19
12
15
21
20
11
12
15
13
14
Figure 134
Strip Brush Notches
29720
18
18
16
17
18
19
20
20
13