Great Plains
| 411-332M | 2019-02-19
50
3P3025AH
Operating Instructions
Long-Term Storage
1. Complete Short-Term Parking on page 49, then do
the following procedure. Park the planter indoors if
possible.
2. See “
” on page 90. Clear all
seed from hoppers and meters.
3. Latch hopper lids.
4. Remove seed discs from meters (this is primarily to
relieve pressure on brushes). Clean discs of residue
build-up (see Caution at right). Use mild soap,
non-abrasive scrubbers, and hot or warm water. If
using sealed storage, dry discs prior to storage.
5. Tie or tape a small plastic bag over ends of all seed
delivery tubes to prevent insects from entering or
nesting.
6. Close seed inlet shutters at meters (to prevent pest
entry to seed hoses). Thoroughly clean seed and
seed treatment residue from seed meters. See
” on page 91, for more
information.
7. Clean planter of mud, dirt, excess oil and grease.
8. Lubricate all points listed in Maintenance.
9. Apply grease to exposed cylinder rods to prevent
rust.
10. Inspect planter for worn or damaged parts. Make
repairs and service during off season.
11. Use spray paint to cover scratches, chips, and worn
areas on the planter to protect the metal.
12. Cover planter with a tarp if stored outside.
Possible Chemical Hazard:
Seed discs will have talc and graphite residue, and may have
residues of hazardous seed treatments. Do not wash discs
where food is prepared, or where cookware or dinnerware is
washed. Wear gloves when washing discs. Avoid spray.
Although the discs are dishwasher-safe, do not wash them in
an appliance also used for food cookware or dinnerware.
