GREAT PLAINS SPARTAN II, Operator'S Manual, Page: 87 / 131

Great Plains | 166-486M | 2020/10/08 80
Spartan
II
607 Table of Contents Index Maintenance
8. Turn the tractor key to OFF, then remove the
tractor key.

Cart Wheels
Review the entire procedure. Great Plains suggests
performing a complete operation on one wheel at a
time, so that there is a fully-assembled wheel to use
as an assembly reference.
Cart Wheel Removal
1. Park the drill on a solid, level surface.
2. Unfold and lower the drill.
3. Stop the tractor engine and take the key with you.
4. Chock cart tires, caster wheels, and gauge
wheels to prevent movement.
5. Put the tractor transmission in park. Release
tractor service brake and tractor parking brake.
6. If the drill has air brakes:
a. Disconnect the red gladhand first and then
the yellow gladhand. Close the covers on the
gladhands. Store the gladhands on the
mounting bracket.
b. Locate the button for the shunt valve (4) on
the left-hand side of the machine near the
ladder. Push the button all the way in to
empty the air reservoir. This will release the
air from the brake system.
7. If the drill has hydraulic brakes:
a. Rotate the shaft in the emergency valve (1) to
release the pressure in the accumulator (2).
Releasing the pressure in the accumulator
releases the brakes.
b. Disconnect the hydraulic line (3) from the port
for the trailer brakes on the tractor. Apply the
tractor parking brake only after trailer brake
disconnection.
8. Loosen the wheel hardware on the cart wheel to
be removed. It is recommended that only one
cart wheel be removed at a time.
9. Put the correct lifting equipment under the
crossbeam below the axle near the tire (5). Raise
1
2
3
4
38343
4
38208
38195
S/N C1009F-
1
3
2
68816
S/N
3
1
2