GREAT PLAINS SPARTAN II, Operator'S Manual, Page: 36 / 131

Spartan
II
607 Table of Contents Index Operation
Great Plains | 166-486M | 2020/10/08 29
When the monitor is activated, the wing gauge
wheels are positioned automatically as the wings are
raised or lowered.
When the monitor is not activated, the wing gauge
wheels must be positioned manually using a tractor
remote lever.
Unfolding
1. Move the drill to solid, level ground with adequate
overhead and side clearances for the unfold
operation.
2. Set locks for disengage.
At each wing, rotate the orange spring locking
handle (1) (top forward). The locking bar (2) may
or may not raise to vertical position at this time.
3. Retract fold cylinders.
a. Press Fold Enable softkey (if displayed).
b. Retract the fold circuit to lift the wings off the
wing fold lock bars. Set the circuit lever to
neutral (not float) to hold wings off locking
bars.
4. Fully raise the drill (page 32) and deploy the wing
gauge wheels.
If the monitor is not turned on, use the hydraulics
to lift the implement frame slightly at the lock.
Hold the circuit at extend for a few seconds after
the gauge wheels (3) are fully deployed.
5. Extend the fold cylinders to:

Extend the gauge wheels to the raised
position.

Lower the wings.
One wing may reach the ground before the
other. It is common for unfolding to be
slightly unequal.
6. Hold the lift circuit at extended for several
seconds after the gauge wheels contact the
ground to:

Make sure the center lock cylinder activates
and disengages the lift lock.

Re - phase the lift cylinder to make sure the lift
cylinders are at the same heights.
7. Set the fold circuit to float or neutral.
32460
1
2
32459
31145A
3
i
31142A