GREAT PLAINS PL5200, Operator'S Manual

Page: 103 / 110

PL5200 Planter Table of Contents Index Option Installation
Great Plains | 411-825M | 12/07/2020 96
Option Installation

Inside Disk Scraper Installation
Start with the left-hand row unit and repeat the
following steps for each row unit.
1. Insert the 3/16 x 3 inch bolt (1) from the rear,
through the lowest hole of the bracket (2).
2. Place the tube (3) over the bolt (1).
3. Place the spacer (4) on the bolt (1) with the larger
diameter toward the bolt head.
4. Put the left scraper blade (5) on the spacer (4),
followed by the right scraper blade (6).
5. Fasten the scraper assembly with a flat washer
(7), lock washer (8), and nut (9).
6. Tight the nut to the correct torque from the
“
Torque Value Chart
” on page 82. Make sure
the disks pivot freely.
7. Install the spring (10) by connecting the spring
between the disks using the small top holes.
8. Remove one or both opener disks to gain access
to the opener frame (11).
9. Install the scraper assembly (12) between the
middle four lower square holes (13) of the opener
frame.
10. Secure with two 5/8 x 2 1/2 inch bolts (14) and
whiz nuts (15).
11. Reinstall the disk.
29227
1
3
2
4
5
6
7 8
9
10
29853
15
11
13
12
14