GREAT PLAINS NTA3007HD, Operator'S Manual

Page: 68 / 178

Great Plains | 166-207M | 02/26/2019 Table of Contents Index 62
NTA907HD and NTA3007HD Table of Contents Index Operating Instructions
Mechanical Checklist Page
q
Check transport and gauge wheel tire pressure 144
q
Tongue height preset 22
q
Air Drill unfolded 25
q
Tongue front latch hook engaged 31
q
Transport locks moved to FIELD 27
q
Wings aligned at unfold 127
q
Marker initial length set 162
q
Marker disk angle set 98
q
Check auger stowed. 52
q
Check ladder stowed. 44
Electrical Checklist Page
q
Verify electrical hookups solid 22
q
Check seed monitor terminal and observe any
diagnostic messages
a
q
Configure seed monitor for crop a
q
Set CFM MASTER off, and
Marker switch on (if markers will be used).
60
a. Refer to DICKEY-john Air Cart Control manual.
Hopper and Air System Checklist Page
q
Meter doors closed 46
q
Manifold to hopper seal
q
Materials loaded 53
q
No air leaks (except from seed box) -
q
Hose routings - no sags, no pinches (check
wing-folded & field positions)
-
q
Hoses fully connected to meters, towers and
openers
-
Frame Mounted Coulter Checklist Page
q
Coulter to row alignment 91
q
Coulter down-force 92
Row Units Checklist Page
q
Preset depth handles alike. 97
q
Preset down force springs alike, except in
tracks.
94
q
Check wheel scraper gaps (if installed) 95
Hydraulic System Checklist Page
q
Check tractor hydraulic reservoir full -
q
Inspect connections for leaks -
q
Perform a raise and lower operation 32
q
If auger-equipped, set selector valve to FAN. 59
q
Check fan operation 58
q
Set CFM switch “Marker” on if markers used 60
Meters and Drive Checklist Page
q
Unused meter disabled by removing gear 75
q
Correct DRIVER/DRIVEN rate Range gears
installed on meter(s) in use
75
q
Correct optional flutes for rate Range a
q
Variable rate gearbox set per calibration 76
q
Check contact tire inflation 144
q
Check chain tension. Re-connect any loose
idler tensioning springs.
154
a. Refer to Seed Rate manual.