
3P1006NT
Assembly
Great Plains | 151-144U | 2019/03/14
69
Dual Seed or Fertilizer Hose
1.
In the middle hole (1) of the opener, install an
opener adapter (2). Secure with two #10
self-tapping screws (3).
2. Insert a fertilizer tube (4) in the opener adapter.
Add a reinforcement ring (5) and secure with two
#10 self-tapping screws (3).
3. Open the band clamp (6) and place it onto the
inlet end of the hose (7), up against the ribs. Slide
the inlet end onto the fertilizer drop tube or feeder
cup. Move the clamp to about one inch below the
end of the hose. Tighten the clamp.
4. Place a 1-1/2 inch hose clamp (8) on the outlet
end of the hose, up against the ribs. Slide the
outlet end of the hose fully onto the fertilizer tube
inlet. Move the clamp until it is about 1/2 inch
from the reinforcement ring.
5. Repeat the above steps for each opener.
Native Grass Hose
1.
Insert the native grass tube (1) into the middle
hole (2) in the opener frame. Secure with two
#10 x 3/4 inch screws (3) and flat washers (4).
2. Place a band clamp (5) onto the inlet end of the
native grass hose (6). Slide the end of the hose
onto the native grass feeder cup. Tighten the
clamp.
3. Place the 2-5/8 inch hose clamp (7) onto the
outlet end of the hose, up against the ribs. Slide
the outlet end of the hose fully onto the native
grass tube inlet. Move the clamp to halfway onto
the hose neck.
4. Repeat the above steps for each opener.
2
3
1
4
5
3
8
7
6
38802
2
1
4
3
5
6
7
38803