![GREAT PLAINS 1510P Operator'S Manual Download Page 23](http://html1.mh-extra.com/html/great-plains/1510p/1510p_operators-manual_2259407023.webp)
1510P & 1520P
Preparation and Setup
Great Plains
| 118-732M | 4/4/19
19
20 Series Openers
Refer to Figure 5
Initially adjust drill so bottom of opener tube runs 24
inches above ground when drill is lowered in the field.
Refer to Figure 6
To adjust:
1.
Loosen jam nut near top clevis of each gauge-
wheel turnbuckle. Figure 6
NOTE: Jam nut is left-hand threaded.
2.
Make sure upper clevis (2) is in upper mount hole
as shown.
3.
Set turnbuckle length. Turn turnbuckle to shorten or
lengthen as necessary. Initially set length to 17
1
/
2
inches between pin centers to achieve the 24-inch
dimension mentioned above. When adjusting the
turnbuckle length, remember:
•
Lengthening turnbuckle raises drill.
•
Shortening turnbuckle lowers drill.
4.
After adjusting both turnbuckles to the same length,
tighten jam nuts.
5.
Level drill with top three-point link.
Refer to Figure 7
NOTE: When drill is level, parallel links will be
running slightly uphill towards the front.
The 1 to 1
1
/
2
inch dimension shownFigure 7 is a
general dimension that will vary with planting
conditions.
Make sure the opener mount is running higher than the
opener body. This will ensure an ample reserve for opener
upfloat in case the opener strikes a rock or other object.
Figure 5
Initial Operating Height
18280
Figure 6
Gauge-Wheel Turnbuckle
12067
Figure 7
Leveling the Drill
18288