PAGE 2 OF
5
INSTRUCTIONS FOR INSTALLATION AND USE
Fig. 2
Fig. 3a
Fig. 3b
STEP 1
: Find a clean flat surface to work on and
assemble the mounting brackets to the PowerLoader.
A
. Remove the two 2” Quick Clip pins and fold the
Power Loader out. This will allow attachment of
mounting brackets to the vertical brace on the Power
Loader.
(See Fig. 2)
A
. Start with the left mounting bracket and attach it to the left vertical brace of the Power Loader facing the
angle to the outside of the vertical brace.
(See Fig. 3A & 3B)
Secure using two 1/4” x 2 1/2” bolts, washers
and wing knobs. There are
4
nylon spacers provided for minor adjustments to the mounting brackets. Next,
attach the right mounting bracket to the right vertical brace.
A
. Next, fold the Power Loader to it’s original position and replace the two 2” Quick Clip pins.
A
. Place the two horizontal arms on ATV/UTV front rack and slide the Power Loader towards the
ATV/UTV until it touches the front of the ATV/UTV. Secure to the front rack with the U-Bolts provided
(see Fig. 4A & 4B). **NOTE**
If adjustments are needed to fit the horizontal arms to the rack, use the four
nylon spacers or the mounting brackets can be moved to the inside of the vertical braces on the Power
Loader. The Power Loader can be adjusted to fit most ATVs/UTVs.
