10
M_LS900 Fibre - LS900 Edge_EN_C
E. Introduction
1. Presentation
The LS900 Fibre is a marking machine equipped with a fiber-type laser source. This type of laser offers very
high quality marking on a wide range of materials.
The LS900 Edge machine has 2 laser source(s): fiber, CO
2
. It allows an even wider range of materials to be
marked.
2.
Identification of the marking equipment
The marking equipment is identified by:
•
1 identification plate on the rear face
Have the model and serial number of the equipment available when contacting Gravotech.
3.
Work station safety
•
Turn off the machine before beginning any cleaning, maintenance or repair procedure.
•
Never operate the machine without the protective covers properly mounted.
•
Never operate the machine if the doors are damaged or do not close properly.
Air extraction system
•
Never operate the machine without a fume and gas extraction system that is properly configured,
installed and maintained in good working order.
•
The gases and fumes from the marking process must be extracted from the machine and discharged
outside.
Handling the machine
•
Never move or lift the machine without the assistance of lifting rings and an appropriate vehicle. Serious
injury can occur if incorrect lifting techniques are used. A lifting kit is available as an option.
• The head must be handled with the greatest care.
•
In the event of an extended period of non-use, unplug the power cable and protect the machine.
•
Never move the head manually unless the machine is jammed mechanically.
•
Never pour or spill liquid on the machine (drinks, cleaning products, etc.) except where recommended by
Gravotech (example: lubrication).