62
M_LS100IQ EX Energy_EN_C
Preventive maintenance
6. Autofocus adjustment
To adjust the autofocus, the machine must be fitted with a 2 in lens and the user must only use the
gage marked 2".
Remove all the tools. Remove any object from the table. The head has to move at high
speed towards the center of the table in order to perform the adjustment.
1.
Switch off the machine.
2. Close the door of the machine.
3. Switch on the machine.
The screen below appears:
L01 SETUP
FPGA
X.X
The machine emits an audible signal. The following screen is displayed for 3 seconds:
<< GRAVOGRAPH >>
FPGA
X.XX
LCD
SOFT
X.XX
32
Mo
BOOT
X.XX
4. While this screen is displayed, press the key:
.
5. Select the following menu:
LASER SETTINGS
TICKLE
RE-ALIGN MACHINE
USING TIME XXX
6.
To confirm, press the key:
.
7. Select the following menu:
X-Y ADJUSTMENT
Z ADJUSTMENT
ALIGNMENT MODE
8.
To confirm, press the key:
.
The head moves towards the middle of the engraving table. An autofocus is performed automatically.
