57
M_LS100IQ EX Energy_EN_C
Adaptable accessories
3.
Compressor kit (Air assist)
This accessory is pre-assembled on a plate to install on the machine.
Installation - Use: Refer to the manual.
Used to deliver compressed air for the Air assist function without having to connect an
external compressor to the air inlet (compressed air supply for air assist).
4. Honeycomb cutting table
Used to support the material to be cut at a distance from the surface of the engraving table to minimize the
area of contact with the surface. The cutting table redirects the exhaust air over and under the material to clear
the engraving area of fumes.
To limit the reflection of laser beam, the honeycomb material is reflective only in the area in contact with the
material.
Installation:
1. Set the cutting table down on the machine's engraving table.
2. Place the cutting table so it is resting against the strips of the engraving table.
