Gravely Pro-Stance 48, Owner'S/Operator'S Manual

Page: 12 / 46

EN - 12
NOTICE: Refer to Controls and Features on
page 13 during setup.
1. Remove packaging and unit from
container.
2. Unlock and lower operator platform into
operating position (see To Move the
Operator Platform on page 19).
3. Open bypass valves (see To Push The
Unit on page 19).
4. Push unit onto a level surface.
5. Close bypass valves.
6. Check tire pressures (see
Specifications
on page 40).
7. Clip cable tie and remove wrap from
steering levers.
8. Check steering lever positions (see
Steering Lever Adjustment on page 28).
9. Remove battery from unit and charge
(see Battery on page 27).
10. Check engine oil level and add if needed
(see engine manual).
11. Check hydraulic fluid level and add if
needed (see Check Hydraulic Fluid Level
on page 24).
12. Fill engine fuel tank with clean fuel (see
Filling Fuel Tank on page 17).
IMPORTANT: See engine manual for fuel
type.
13. Inspect all hardware and tighten if loose.
14. Check safety interlock system functions
(see Safety Interlock System on
page 14).
15. Lubricate all fittings (see Maintenance
Schedule on page 21).
16. Place discharge chute in the operating
position.
17. Check that mower deck is level per
factory standards (see Leveling the
Mower Deck on page 34).
18. Check all control functions and ensure
unit operates properly (see Controls and
Features on page 14).
SETUP
WARNING: AVOID INJURY. Read
and understand entire Safety section
before proceeding .
CAUTION: Avoid injury! Explosive
separation of tire and rim parts is
possible when they are serviced
incorrectly:
• Do not attempt to mount a tire
without the proper equipment and
experience to perform the job.
• Do not inflate the tires above the
recommended pressure.
• Do not weld or heat a wheel and
tire assembly. Heat can cause an
increase in air pressure resulting
in an explosion. Welding can
structurally weaken or deform the
wheel.
• Do not stand in front or over the
tire assembly when inflating. Use
a clip-on chuck and extension
hose long enough to allow you to
stand to one side.
WARNING: FAILURE OF
INTERLOCK together with
improper operation can result in
severe personal injury.
WARNING: FAILURE OF
CONTROLS could result in death
or serious injury.