Gravely 994149, Operator'S Manual

Page: 27 / 44

EN - 25
Lubricate Caster Wheel Bearings
1. Place unit in service position. See
Service Position on page 19.
2. Support unit so front wheels are off the
ground.
3. Remove wheel from front fork.
See Figure 25.
4. Remove end caps from wheel hub.
5. Pump grease into fitting until grease
squeezes through the seal in the wheel
hub.
6. Wipe away excess grease.
7. Reinstall end caps onto wheel hub.
8. Reinstall wheel into fork and lower unit to
ground.
IMPORTANT: After tightening bolt, tire should
not have any side-to-side play. Tighten bolt
until there is a slight amount of drag on the
wheel bearing. The wheel should not spin
freely.
ELECTRICAL SERVICE
The fuse/relay panel is located on the right
side of the tower accessible from the front.
Replace Fuse
The main fuse is located on the right side of
the engine behind the remote starter
solenoid. Keep it tucked in this location to
protect it from damage.
NOTICE: To avoid damaging the circuit,
replace fuses with fuses of the same
amperage rating. Determine the cause of
electrical failure and repair before replacing
failed electrical components.
See Figure 26.
1. Remove defective fuse.
2. Determine cause of fuse failure and
repair condition.
3. Install new fuse.
Figure 24
1. Dust Cap
2. Grease Fitting
1
2
1. Grease Fitting
2. End Cap
1
2
Figure 25
SERVICE AND
ADJUSTMENTS
WARNING: AVOID INJURY.
Read and understand the
Safety section before
proceeding.
Figure 26
1. Fuse Box
1