GRAUPNER mx-12 Hott, Programming Manual

Page: 70 / 200

70 Program description: model memories
The section on pages 24 and 25 explains the basic
method of using the buttons, while the previous two
double-pages explains how to move to the Multi-function
list and reserve a new model memory. At this point we
wish to start with the “normal” description of the indi-
vidual menu points in the sequence in which they occur
on the transmitter itself. For this reason we start with the
menu …
Model memory
mod.mem.
servo set.
D/R expo
wing mixer
base sett.
contr set.
phase trim
free mixer
servo disp basic sett
fail-safe telemetry
The transmitter can store up to twenty complete sets
of model data, including the digital trim values set by
the four trim levers. The trims are automatically stored,
which means that the settings you have carefully estab-
lished through test-flying are never lost when you swap
models. A pictogram of the selected model type, and - if
you have entered a model name in the “
Base settings
”
menu (pages 74 and 82) - the name appears in all three
sub-menus of the “
Model memory
” menu following the
model number.
If necessary, use the arrow buttons of the left or right-
hand touch-key to select the “
Model memory ” menu,
then briefly touch the SET button of the right-hand
touch-key:
Model memories
Calling up a model, erasing a model, copying model  model
clear model
select model
clear model
copy mod–>mod
=>
=>
=>
=>
export to SD
import from SD
=>
=>
Use the arrow buttons  of the left or right-hand
touch-key to select the “clear model” sub-menu, then
touch the
SET button.
Select the model to be erased using the arrow buttons

of the left or right-hand touch-key, …
01
03
04
ULTIMATE 02
GRAUBELE
STARLET
BELL47G
model to be cleared:
R08
R08
R08
–––
… then touch the
SET
button again; the program re-
sponds with the security query:
model
GRAUBELE
to be erased ?
NO YES
01
If you answer NO , the process is interrupted, and you
are returned to the previous screen page. If you answer
YES with the  button of the left or right-hand touch-
key and confirm your choice with the SET button, then
the selected model memory is erased.
select model
select model
clear model
copy mod–>mod
=>
=>
=>
export to SD
import from SD
=> =>
=>
If you now briefly press the SET button again, you move
to the “Call up model” sub-menu:
01
03
04
05

free

ULTIMATE 02
GRAUBELE
STARLET
BELL47G
06

free

R08
R08
R08
–––
Now use the arrow buttons  of the left or right-hand
touch-key to select from the list the model memory you
wish to use, and confirm your selection by pressing the
SET
button. Pressing
ESC
takes you back to the previ-
ous menu page without switching models.
Notes:
If the warning message “Throttle too high” appears •
when you switch models, the throttle or collective
pitch stick (Ch 1), or the throttle limiter, is positioned
too far towards full-throttle.
If the battery voltage is too low, it may not be possible
•
to switch model memories for safety reasons. In this
case the screen displays the following message:
not possible now
voltage too low