GRASS VALLEY TRINIX NXT -, Installation Manual

Page: 288 / 449

288 Trinix NXT — Installation and Service Manual
Section 13 — Broadlinx Software
Note If you connect to the Internet via a Proxy, you must turn off the Explorer Proxy
settings. To check the Proxy setting, open Microsoft Internet Explorer’s LAN
Settings (Menu bar> Tool > Internet Options> Connections> LAN Settings).
2.
Enter the factory default URL in the address field (This URL is the IP
address for the Broadlinx board):
http://192.168.253.200
The Broadlinx web page will then appear.
Figure 197. Broadlinx Web Page
3.
Proceed to the Broadlinx Installation on page 259 .
Note There is a known issue where the Broadlinx Web page is not accessible if the
Broadlinx board is started without an Ethernet cable or if the Ethernet cable
is removed and then inserted after HTTP Daemon is started. However, the
Trinix Matrix will be listed in the NetConfig application. To correct this issue,
insert the Ethernet cable and then reboot the Broadlinx board.
Complex Network
If the network includes additional PCs, connections to additional net-
works, and so forth or if there is more than one Broadlinx board, then the
factory default network settings of the boards will need to be adjusted to
avoid conflicts.
See the Configuring the PC’s Network Settings section, for the initial network
configuration steps.
When the Broadlinx web page appears:
1. Click the
Configure
button, at the bottom of the page, to navigate to the
Configuration page ( Figure 198 ). You should see the current Network
Interface parameters. Your parameters will differ from those in the
example shown in
Figure 198 .