Controlling an external device from T2 with AMP/BVW
(R1-VTR mode)
The operation of T2 to control an external device (VTR) with the AMP
command (via Ethernet) or BVW command (via RS422), using T2 as a
controller (master) is described in this part.
When you use the BVW command, you do not need to perform steps 1 to 3.
1
Tap [Config.] on the touch screen LCD of T2.
2
Tap [General], and then tap the [Network-1] tab or [Network-2] tab.
3
Set the IP address of T2.
General – Network-1/Network-2 settings
4
Tap [R1], and then tap [Timecode & Remote].
5
Select a remote protocol from the list of [Remote Protocol(VTR
Mode):].
If [BVW] is selected, proceed to step 7.
6
If [AMP] is selected in step 5, set the IP address and channel of
the VTR.
7
Tap [OK].
8
Press the [R1] button, and then tap [VTR].
Controlling of an external device from T2 with AMP command or BVW
command will be enabled.
Controlling T2 from an external controller with AMP/
BVW (R1-remote mode)
The settings of T2 to control the R1 channel of T2 from an external
controller with the AMP command (via Ethernet) or BVW command (via
RS422) is described in this part.
T2 accepts commands from the external controller as a device (slave).
1
Tap [Config.] on the touch screen LCD of T2.
2
Tap [R1], and then tap the [Timecode & Remote] tab.
3
Select a remote protocol from the list of [Remote Protocol(Remote
Mode):].
240
T2 Elite 2/Pro 2/Express 2/Elite/Pro/Express User Manual
May 16, 2016
Section 11 ― Remote Control
