Section
11
Remote Control
This section describes the remote control using GPI input/output, AMP
command, BVW, and TC Chase command.
Remote control using AMP/BVW/TC Chase
Overview of AMP control
For T2, the following AMP control are available via Ethernet.
•
Controlling an external device from T2 with AMP (R1-VTR mode)
•
Controlling T2 from an external controller with AMP (R1-remote
mode)
•
Controlling T2 from an external controller with AMP (P1/P2-remote
mode)
TIP
•
For AMP specifications and settings, refer to the Grass Valley
AMP protocol documents on our website or the following
URL.
http://www.gvgdevelopers.com/concrete/apis/amp_protocol/
documentation/
•
For sample source codes of AMP protocol, refer to our website
or the following URL.
http://www.gvgdevelopers.com/concrete/apis/amp_protocol/
amp-socket-connection-example/
• For the AMP commands list, see “Appendix”.
•
The port number of T2 for connecting AMP is 3811.
•
AMP control sample programs can be downloaded from our
website.
NOTE
•
The AMP commands for T2 do not support controlling via
RS422.
•
AMP control sample program software is not eligible for
product support.
238
T2 Elite 2/Pro 2/Express 2/Elite/Pro/Express User Manual
May 16, 2016