28
Router Web Browser User Interface
Salvos Configuration
Click on the
Apply
button to commit your changes, or
Cancel
to exit the pane without
making any changes.
Reset to Factory Defaults
The
Reset to Factory Defaults
button can be used to return all router user settings to
factory defaults.
Salvos Configuration
The Salvos screen lets you configure up to eight salvos for the selected Sirius router. Each
salvo can route any number of sources to any number of destinations, including the same
source to multiple destinations. Crosspoints not included in a salvo remain unchanged.
When you first select the Salvo screen the eight Salvo buttons are shown. Buttons with
currently configured salvos are colored green.
Enable Exit Page Warning
The
Enable Exit Page Warning
checkbox enables or disables the display of a warning
message if you leave the Salvo configuration screen without saving.
Fig. 3-7: Initial Sirius Salvos Screen
Clicking on one of the eight Salvo buttons selects that salvo for configuration. After
selection, a router table appears below with Sources listed vertically and Destinations listed
horizontally. After a salvo is configured, you will need to save the crosspoint takes for that
salvo.
Summary of Contents for SIRIUS SCR 1616-12G
Page 2: ...ii Notices ...
Page 24: ...6 Introduction In This Manual ...
Page 40: ...22 Installation Identify Button ...
