14
Installation
LAN Connection Using a Hub or Switch
• Select and name Sirius routers and control panels
• Assign a Sirius panel to be able to control specific Sirius routers
• Name sources and destinations
• Make Source to Destination assignments (signal routing)
• Change router operating mode (Normal, Dual Mode, Quad Mode)
• Set a variety of operational and monitoring options
LAN Connection Using a Hub or Switch
In a LAN connection, connect one or more Sirius routers to your LAN or closed network
using Cat 5 Ethernet cable and an Ethernet hub or switch; then power up the equipment.
Fig. 2-3: Sirius Routers on LAN with Web Browser UI
Setup and Control Methods
Regardless of direct connection or LAN connection, Sirius are controlled over a network by
connecting to Sirius’ internal web server with a standard web browser on a Mac or PC. To do
this you first need to establish a network connection between the computer and the Sirius
to be controlled. There are various methods supported for doing this depending on the
operating system and/or web browser being used.
When using Sirius in a DHCP or Static IP addressed network, it is best to select and maintain
a consistent network scheme. If you use a mix of DHCP and Static IP addresses, inconsistent
performance can result. The most stable operation is achieved when all IP addressing is
either DHCP or Static.
Control Unlimited Sirius
Routers via TCP/IP
LAN Switches or
Hubs
Web Browser
User Interface
Summary of Contents for SIRIUS SCR 1616-12G
Page 2: ...ii Notices ...
Page 24: ...6 Introduction In This Manual ...
Page 40: ...22 Installation Identify Button ...
