7
2
Installation
Overview
Sirius SDI routers are easy to set up and use. All of the steps for Sirius installation and
configuration are documented in this chapter, summarized as follows:
1 Install the chassis in an appropriate rack. If you are mounting multiple Sirius units, try to
place them visually in the same area so if you communicate with them via a network
attached computer, you can use the Sirius’ Identify feature to flash the corresponding
LED of the unit you are communicating with. Ensure you have an Ethernet cable routed
to where the Sirius will be placed.
2 Assemble the Ethernet network connections to a closed network or LAN using Cat 5
Ethernet cable and any required switches and hubs.
3 Connect the Sirius to power, connecting the power cord to mains AC.
4 If necessary, configure device network settings for operation in your facility.
5 Cable the system SDI video source and destination equipment and reference signals.
6 If operating with Dual Link or Quad Link signals, select the appropriate Sirius operating
mode.
WARNING
Do not defeat the safety purpose of the grounding-type plug
Caution
To meet safety regulations for leakage current when using redundant power supplies,
connect the Sirius dual power supplies to separate branch circuits
What Is In The Box?
When you unpack your Grass Valley Sirius SDI device, you will find the following
components:
• Sirius SDI router or Sirius control panel
• AC adapter and AC power cord
• Please save all packaging for shipping Sirius should you wish to do so when moving or
sending it in for service.
Summary of Contents for SIRIUS SCR 1616-12G
Page 2: ...ii Notices ...
Page 24: ...6 Introduction In This Manual ...
Page 40: ...22 Installation Identify Button ...
