GRASS VALLEY PERFORMER, Instruction Manual

Page: 91 / 182

2-59
Control Panel Reference
TEN–XL SCP Switch Configuration
Controlling More Than One Performer
The TEN-XL Serial Control Panel may be set up in one of two
modes, Dual and X-Y. In the Dual Mode, it can control up to two
Performer switchers. In the X-Y mode, it can control up to ten
Performer switchers.
Dual Mode: Controlling Up To Two Performers
In the illustration below, note that there are two rows of ten
selection buttons. In Dual Mode, each of the button rows selects a
source for one Performer (two rows = two switchers).
X-Y Mode: Controlling Up To Ten Performers
Again, in the illustration below, note that there are two rows of ten
selection buttons. In X–Y Mode, the left button row selects a
source; the right button row selects one of ten Performers upon
which that source selection will be made.
In X–Y Mode, each button in the right button row (switcher
selection) determines the switcher address to which the routing
message will be sent. Button 1 selects the switcher at address 0,
Button 2 selects the switcher at address 1, and so on through
button 10, address 9. (Because binary count begins with 0, the
addresses are 0 through 9.) Thus, if you are using this panel to
control multiple Performers, they must be assigned to addresses 0
through (up to) 9 as described on page 2 - 60.
Grass Valley Group
SERIAL CONTROL PANEL
1 2 3 4 5 6 7 8 9 10 1 2 3 4 5 6 7 8 9 10
TEN X L
3282-34