6.15.3
5
LDK 4016/05 7-inch Viewfinder
User's Guide
How to use PIP
The PIP signal is controlled by a toggle switch and
works as follows:
The first time toggle up gives the PIP signal in the
top left corner of the total picture.
The second time toggle up moves the PIP signal
to the top right corner of the picture.
The third time toggle up moves the PIP signal to
the bottom right corner of the picture.
The fourth time toggle up moves the PIP signal to
the bottom left corner of the picture.
The fifth time toggle up moves the picture back to
the top left corner of the picture.
Holding toggle up longer then a second switches
off the PIP signal.
After switching on the PIP signal giving a toggle
down switches the PIP in reverse mode. This
means PIP signal total view and Camera signal
PIP view, which can be recognised on the flashing
border of the PIP view.
Toggle down again switches back to normal PIP
mode.
Note:
When the PIP signal is switched on, the
Viewfinder shows the Camera signal and the PIP
signal shows the Ext. 1, Ext. 2 or the Y/Ext signal,
which can be operated from the Rear Control
Panel of the LDK10 Camera.
Toggle one
Toggle two
Toggle three
Toggle four